MKS Base V1.5 3D Printer Control Board With USB Mega 2560 R3 Motherboard Compatible With RepRap Ramps1.4

€ 42,99

Descriptions: - This is the combination of MEGA2560 + RAMPS1.4 + 5 x A4982 drivers (remix board) - Firmware can use the same configuration as RAMPS1.4 - It is suitable for dual-Extrude printer - Easy DISPLAY + SD-CARD connector, RepRapDiscount SmartController compatible pin header on board - 3x temperature ADC connectors for thermistors - Up to 5 motor drivers with A4982 - 4x PWM capable power mosfet outputs with voltage selector for MainPower.(Bed, Extruder0, Extruder1, Fans) - 4 layers PCB, optimize heat dissipation. - 6x end stop connectors with power supply Xmin/Xmax/Ymin/Ymax/Zmin/Zmax - Recoverable fuse for short-circuit protection. - USB Driver Chip FT232RL, you can get files from ftdichip to setup driver: Ftdi-x86.zip Package included: 1 x Control Board